Argent CD20SW0801 Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Argent CD20SW0801. Argent CD20SW0801 2 pagina's. Centra range with drawers

Pagina afdrukken

IMPORTANT:

IT IS NECESSARY TO SECURE THE

CABINET THROUGH THE SOLID

BACK BOARD INTO A SECURE

SUBSTRATE.

FOR CAVITY WALLS, CABINET MUST

BE SECURED THROUGH THE WALL

INTO EITHER WALL STUDS OR

NOGGINS.

FOR SOLID WALLS, SUITABLE WALL

PLUGS/FIXINGS WILL NEED TO BE

USED.

PRIOR TO INSTALLATION

Argent recommends a qualified trade

person fit your bathroom furniture.

Ensure your furniture is installed to

relevant building codes and Australian

Standards.

Please note, Argent will not be liable

for the cost of installation or removal

of the furniture and the warranty will be

voided if damage occurred during or

after installation.

MEASURE & MARK

Fit wall hung basin at required height

to secure stud or frame, ensure level.

(1)

Remove

drawer of cabinet and set

aside carefully.

Locate wall studs to secure cabinet.

Measure and mark fixing positions

for drilling. Fix through multiple studs/

noggins to ensure secure fixing, a

minimum of 6 fixing positions is required.

For solid walls, use fixings appropriate to

your wall substrate. Mark and cut holes

in the cabinet for hot and cold water

inlets and waste exit pipe as required.

See relevant specification sheet for

specific cut outs.

INSTALLATION

Fit the wall hung cabinet to the required

height and location to studs and/or solid substrate, ensure the cabinet is level. The drawer of cabinet can be removed

by pulling the clasps on the underside front towards the outer edge of the drawer. Set the drawer aside carefully.

Ensure drawers are adjusted to sit square as

they may have moved during transportation.

Ensure runners are locked in place.

FITTING TAPWARE & WASTE

If tapware and waste are still to be fitted, the drawer of cabinet can be

removed by pulling the clasps on the underside front towards the outer

edge of the drawer. Set the drawer aside carefully. Fit tapware and

waste to the basin.

Test to ensure there are no leaks.

Replace the drawer.

FIT OFF, ADJUST & FINISH

Replace drawer and adjust to ensure all square with the installed vanity.

Put a bead of bathroom grade silicon around the rear edge of the stone

top & or basin where they touch the wall & or the stone top for sealing .

Drawer Release

Feel under the drawer for

release catches. Squeeze

catches, lift up and towards

you to release the drawer from

the runners.

Basin Sealing

I MP OR TA N T:

U S E O N LY b a t h r o o m

g rad e si l i co n s ea l an t

Epoxy type glues

MUST NOT BE USED.

Put a bead of bathroom grade

silicon around the back edge

of the basin and where the

basin touches the wall. Do not

tighten the basin bolts to avoid

damaging the basin.

I M P OR TA N T:

INSPECT THE FURNITURE

TO ENSURE NO DAMAGE

HAS OCCURRED DURING

TRANSIT.

IF DAMAGE HAS

OCCURRED, OR VISIBLE

DEFECTS EXIST, DO

NOT PROCEED WITH

INSTALLATION AND ADVISE

ARGENT IMMEDIATELY.