DigitaLinx DL-HDE100 소유자 매뉴얼 - 페이지 8
{카테고리_이름} DigitaLinx DL-HDE100에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigitaLinx DL-HDE100 16 페이지. Extender set transmits hdmi, bidirectional ir, rs232 and
ethernet up to 100 meters away using a single category 6 twisted pair cable.
DigitaLinx DL-HDE100에 대해서도 마찬가지입니다: 설치 매뉴얼 (4 페이지), 빠른 설치 매뉴얼 (8 페이지)
페이지 인쇄
DL-HD70 Owners Manual
Quick Start
1.
Connect video source to transmitter HDMI IN
2.
Connect display technology to receiver HDMI OUT
3.
Connect transmitter and receiver together with a shielded Category 6 cable
4.
Connect control (optional)
5.
Connect Ethernet (optional)
6.
Apply power to either transmitter OR receiver to power entire circuit
Connecting a Video Source
HDMI Input (Transmitter)
Connect an HDMI source device to the HDMI input on the DL-HDE100 transmitter labeled HDMI IN using an
HDMI cable that is less than or equal to 5 meters in total length. For HDMI source devices that are further away,
an active HDMI cable may be required to complete the connection.
Connecting a Display
HDMI Output (Receiver)
Connect the display to the HDMI output on the DL-HDE100 receiver labeled HDMI OUT using an HDMI cable
that is less than or equal to 5 meters in length. It is recommended to keep the DL-HDE100 receiver near the
display input as it is not recommended that an active HDMI cable be used on the HDMI output on the DL-
HDE100 receiver.
8