DigitaLinx DL-HDE100 소유자 매뉴얼 - 페이지 9

{카테고리_이름} DigitaLinx DL-HDE100에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigitaLinx DL-HDE100 16 페이지. Extender set transmits hdmi, bidirectional ir, rs232 and ethernet up to 100 meters away using a single category 6 twisted pair cable.
DigitaLinx DL-HDE100에 대해서도 마찬가지입니다: 설치 매뉴얼 (4 페이지), 빠른 설치 매뉴얼 (8 페이지)

페이지 인쇄

HDBaseT Connection

Connect one end of a Category cable to the DL-HDE100 transmitter labeled TWISTED PAIR, then connect the

other end of the Category cable to the DL-HDE100 receiver labeled TWISTED PAIR

To ensure proper performance of the

UTP cabling at a minimum. Category 5e F/UTP may perform well up to a certain length but may not support power over

HDBaseT reliably longer distances.

For optimized performance use the following Liberty Wire and Cable branded cabling;

Category 6 plenum; 24-4P-P-L6SH

Category 6A plenum; 24-4P-P-L6ASH

Category 6 NON-plenum; 24-4P-L6SH

Category 6A NON -plenum; 24-4P-L6ASH

Connecting RS232 Control

RS232 or serial control signals can be transmitted through the DL-HDE100 using the RS232 connection ports on

he DL-HDE100 transmitter and receiver.

TIA/EIA-568B

P n 1

Or n e/Wh te

P n 2

Or n e

P n 3

Green/Wh te

P n 4

Blue

P n 5

Blue/Wh te

P n 6

Green

P n 7

Brown/Wh te

P n 8

Brown

DL-HDE100

, it is recommended that you use solid core, shielded Category 6

When using shielded category cabling ALWAYS...

....use shielded connectors

....properly ground the category cable

RS232 Wiring

Connect the controller or device RX signal to

TX on the DL-HDE100 extender. Connect the

controller or device TX signal to RX on the

DL-HDE100 extender.

Twisted Pair Wiring

Use TIA/EIA-568B wiring for Category 6

connection between send and receive

units.

DL-HD70 Owners Manual