DigitaLinx DL-S41-H2 소유자 매뉴얼 - 페이지 8
{카테고리_이름} DigitaLinx DL-S41-H2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigitaLinx DL-S41-H2 18 페이지.
DigitaLinx DL-S41-H2에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (8 페이지), 빠른 설치 매뉴얼 (8 페이지)
페이지 인쇄DL-S41-H2 Owners Manual
Connecting Control
RS232 Control Wiring
Using the supplied RS232 3.5mm - DB9 serial breakout cable, connect the controller device to the 3.5mm port
on DL-S41-H2 switcher labeled as RS232. Below is a pin out for the supplied breakout cable.
DL-S41-H2
Tx
Rx
IR Remote Control (Optional)
Connect the IR receiver to the IR input port of the DL-S41-H2, the IR remote is used for input switching and
it also can be used to control source and display devices based on CEC control. To use this feature with a
compatible CEC source and display, turn on the CEC option in the source and displays menu options.
Note: CEC performance may differ for various sources and displays and not all remote functions may be
supported by third party source and display manufacturers.
Apply Power
Plug the power supply into the power input port on the rear of the DL-S41-H2 receiver.
8
Controller or
Device
RXD
TXD
GND