DigitaLinx DL-HDE100 빠른 설치 매뉴얼 - 페이지 4
{카테고리_이름} DigitaLinx DL-HDE100에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigitaLinx DL-HDE100 8 페이지. Extender set transmits hdmi, bidirectional ir, rs232 and
ethernet up to 100 meters away using a single category 6 twisted pair cable.
DigitaLinx DL-HDE100에 대해서도 마찬가지입니다: 설치 매뉴얼 (4 페이지), 소유자 매뉴얼 (16 페이지)
페이지 인쇄
1
1.
DC 18V
• Locking power port, connect DC18V power adapter (either power port can power entire set)
2.
Twisted Pair
• RJ45 HDBaseT connection. Connect Cat6 cable to transmitter
3.
IR In
• 3.5mm IR input port for connection to IR receiver or IR system
4.
IR Out
• 3.5mm IR output port for connection to IR emitter
5.
RS232
• 3 pin Phoenix connector port for connecting / passing RS232 control
6.
HDMI Out
• HDMI output port for connections to display technology
7.
Ethernet
• RJ45 port for passing Ethernet from transmitter location
8.
Mode - Normal- for normal operation. Update- for firmware update process
• The mode switch is used when updating firmware in the extender. A separate document will
provide usage instructions once a new firmware update is available.
Front Panel Diagnostic LEDs:
The DL-HDE100 provides four blue LEDs to indicate the current operating status and to
assist troubleshooting an installation.
Power: Solid, the DL-HDE100 extender is receiving power from the power supply or from the
remote extender via Category 6 cabling.
Status: Flashes once per second, the HDBaseT processor is running.
Link: Solid, the two DL-HDE100 extenders are communicating via Category 6 cabling.
HDCP: Solid, HDCP signal is present in the HDMI stream. Flashes quickly, no HDCP signal is
present in the HDMI stream.
Receiver View
2
3
4
5
6
7
8