ARGENTO ALPHA 사용자 설명서 - 페이지 16

{카테고리_이름} ARGENTO ALPHA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ARGENTO ALPHA 20 페이지. Electric pedal-assisted cycle

8.5 Lighting management

Press and hold the + button for at least 1 second to switch the front and rear lights

on the pedal-assisted bicycle on / off.

Check that the reflectors are present and well tightened in the front and rear

wheel.

Keep the button pressed for at least 2 seconds - to activate the walking assist

function, the same function is interrupted when the button is released -

The assisted walking function allows the bike to activate the motor without

the need to pedal, this function allows the bike to reach a maximum speed of

6 km/h.

Never use the walk assist function while riding, as the electric parts of the

bike could be damaged.

Always use the walk assist function while walking alongside your electric

bike, firmly holding the handlebar grips with both hands.

The battery indicator is complete upon completion of charging the battery of

your pedal assisted bicycle. The battery indicator drops in level as the pedal-

assisted bicycle is used. The battery indicator can fluctuate in the charge

level depending on the use of the pedal-assisted bicycle, for example if you

go uphill the level of the battery indicator can drop rapidly as it has a much

higher battery consumption supplied on your pedal-assisted bicycle.

For a good use and maintenance of the battery it is recommended to fully

charge the battery after each use of your electric bike.

Press the M button for at least 2 seconds to enter the LCD display configuration.

Within the display configuration, press the + and - buttons to change the value of

the single parameter, press the M button to move to the next parameter, press the

M button for at least 2 seconds to exit the LCD display configuration.

9.1 Km / Miles

Indicated by the S7 symbol, press the + and - buttons to switch from a Km / h to

MPH display.

Assisted walking