ACU-RITE 01121 사용 설명서 - 페이지 11
{카테고리_이름} ACU-RITE 01121에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ACU-RITE 01121 16 페이지.
페이지 인쇄
Programmable Alarms
This display features programmable alarms that sound an alert to notify you
when a value (for temperature or humidity) has been reached or exceeded.
When an alarm is triggered, the display emits an audible beep and flashes data
in the affected category. You can customize the alarms by turning ON or OFF
the alarms you'd like activated or deactivated, and by inputting your own values
to trigger the alarm.
Setup an Alarm
1. Press and release the "
set an alarm is shown on the display. "
2. Press and release the "
3. Press and release the "SET" button. The current HIGH alarm value will flash
on the display.
4. Press and release the "
5. Press and release the "SET" button. The current LOW alarm value will flash
on the display.
6. Press and release the "
7. Press and release the "SET" button to end alarm adjustments, OR press
and release the "
Disable an Alarm
1. Press and release the "
disable an alarm is shown on the display. "
2. Press and release the"
3. Press and release the "
4. Repeat steps 1-3, as needed.
Note: To disable ALL alarms at once, press and HOLD the "
10 seconds.
You will automatically exit alarm SET MODE if no buttons are pressed for
10 seconds. Enter alarm SET MODE at any time by pressing the "
" button until the reading for which you wish to
" or "
" buttons until "
" or "
" buttons to adjust the alarm's HIGH value.
" or "
" buttons to adjust the alarm's LOW value.
" button to adjust the next alarm's values.
" button until the reading for which you wish to
" or "
" buttons until "
" button to cycle to the next reading.
11
" will be shown.
" appears.
" will be shown.
" appears.
" button for
" button.