Cisco ASR1006 - ASR 1006 Modular Expansion Base 하드웨어 설치 매뉴얼 - 페이지 42
{카테고리_이름} Cisco ASR1006 - ASR 1006 Modular Expansion Base에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR1006 - ASR 1006 Modular Expansion Base 47 페이지. Lightweight access points
Cisco ASR1006 - ASR 1006 Modular Expansion Base에 대해서도 마찬가지입니다: 배포 매뉴얼 (40 페이지)
페이지 인쇄
Figure 21
Handling a SPA
GND
To install a shared port adapter into a SPA interface processor (SIP), follow these steps:
Step 1
Before you begin, make certain the chassis is grounded.
To insert the SPA in the SIP, locate the guide rails inside the SIP that hold the SPA in place. They are at the top left and
Step 2
top right of the SPA slot and are recessed about an inch.
Carefully slide the SPA all the way in the SIP until the SPA is firmly seated in the SPA interface connector. When fully
Step 3
seated, the SPA might be slightly behind the SIP faceplate. See
Figure 22
Installing and Removing a SPA Into and From a SIP
42
Printed circuit board
Metal carrier
AS R1 00 0-S
IP1 0
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
PW R STA TUS
AS R1 00 0-S
IP1 0
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
PW R STA TUS
SPA -4X OC
3-P OS
Figure
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
22.