Cisco WAP300N 사용자 설명서 - 페이지 15

{카테고리_이름} Cisco WAP300N에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WAP300N 30 페이지.
Cisco WAP300N에 대해서도 마찬가지입니다: 매뉴얼 (9 페이지)

Linksys WAP300N

RADIUS Server

RADIUS Port

Shared Key

RADIUS

Encryption

Key 2

3. After you have entered all required information, click Save Settings

How to use Wireless Media Connector

mode

In addition to the topics below, see the topic "How to set up QoS (Quality of

Service)" on page 20

To select Wireless Media Connector mode:

Setup > Operation Mode

1. Log into the browser-based utility (see "How to open the browser-based

utility" on page 8)

2. Click the Setup tab, then click the Operation Mode page

Enter the IP address of the RADIUS server

Enter the port number of the RADIUS

server The default is 1812

Enter the key shared between the router

and the server

Select a level of WEP encryption, 40/64-

bit (10 hex digits) or 104/128-bit (26 hex

digits)

Enter the WEP key of your network Key

2 is the transmit key used by this device

3. Select Wireless Media Connector, then click Save Settings

We recommend using wireless network site survey to set up your

WAP300N in Wireless Media Connector mode Wireless network site

survey identifies wireless networks with in the range of your WAP300N,

so that you can easily select one of them to connect to For instructions,

see How to run a wireless network site survey below

We recommend using wireless network site survey to set up your WAP300N

in Wireless Media Connector mode Wireless network site survey identifies

wireless networks within range of your WAP300N, so that you can easily select

one of them to connect to

To run a wireless network site survey:

1. Log into the browser-based utility (see "How to open the browser-based

utility" on page 8)

2. Click the Wireless tab, then click the Wireless Network Site Survey

page The site survey runs and displays the following information:

Setting Up: Basics