Cisco WUMC710 사용자 설명서 - 페이지 10
{카테고리_이름} Cisco WUMC710에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WUMC710 17 페이지. 802.11ac
Cisco WUMC710에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 빠른 설치 매뉴얼 (17 페이지)
페이지 인쇄
Linksys WUMC710
Key 1
Enter the WEP key of your network
Tx Key
Key 1 is the transmit key used by the bridge
Authentication
The default is Auto, which allows either Open system or Shared
key authentication to be used Select Open to use open system authentication;
the sender and recipient do not use a WEP key for authentication Select
Shared to use shared key authentication; the sender and recipient use a WEP
key for authentication
Click Save Settings to apply your changes, or click Cancel Changes to cancel
your changes
Wi-Fi Protected Setup
There are two methods available Use the method that applies to the router
you are using
Method #1
Use this method if your router has a Wi-Fi Protected Setup button
1. Click or press the Wi-Fi Protected Setup button on the router
2. Within two minutes, click the Wi-Fi Protected Setup button on the
bridge's Wi-Fi Protected Setup screen
3. After the bridge has been configured, click Close
The Wi-Fi Protected Setup screen displays the Link Status, Network Name (SSID),
and Security method
Method #2
Use this method if your router requests the PIN number of the bridge
1. On the router's Wi-Fi Protected Setup screen, enter the PIN number on
the bridge's Wi-Fi Protected Setup screen Then click Register or the
appropriate button (It is also listed on the label on the bottom of the
bridge )
2. On the bridge's Wi-Fi Protected Setup screen, click OK
3. After the bridge has been configured, click Close
The Wi-Fi Protected Setup screen displays the Link Status, Network Name (SSID),
and Security method
Wireless > Wireless Network Site Survey
Click the Wireless Network Site Survey tab to begin a site survey The Wireless
Network Site Survey screen lists the wireless networks detected by the bridge
Advanced Configuration
9