6
Install Software and
Connect to Your Computer
The software works with Windows
OS 9.1.x to 9.2.x and 10.2.x to 10.3.x. Follow the steps below (for Windows),
or the steps in the next column (for Macintosh).
Note: There is a Security Lock program on your software CD-ROM that lets
you prevent unauthorized use of your CX6600. See the Quick Guide for
instructions on installing and using it.
Windows
1
Make sure the Stylus CX is not
connected to your computer,
then turn on your computer.
Note: If you see several New
Hardware Wizard screens, click
Cancel for each of these screens and
disconnect your Stylus CX. You can't
install your software that way.
2
Insert your Stylus CX software CD-ROM in your CD-ROM or DVD drive.
3
Wait until you see this screen,
then click Install.
Note: If you don't see this screen,
do the following:
For Windows XP: click Start >
My Computer. Then double-click
the Epson CD-ROM icon.
For Windows 98/Me/2000: double-click
Then double-click the Epson CD-ROM icon.
4
Read the license agreement, then click Agree. Several messages
display on your screen.
5
When you see this screen, make sure
your Stylus CX is turned on, then lift
up the scanner.
6
Remove the yellow
sticker and plug the
square end of the USB
cable into the USB port
on your Stylus CX.
Then route the cable in
the slot as shown.
Caution: Make sure the USB cable fits securely into the slot. The USB
connector may snap if the cable is not routed correctly in the slot and
the scanner is closed with force.
7
Close the scanner carefully.
8
Plug the flat end of the
cable into any available
USB port on your
computer.
9
Click Next and follow the
instructions on the screen to install
more software.
Note: It will take several minutes to install the software.
Don't cancel the installation.
10
At the completion screen, print a test page, if desired. When done,
click Next to install additional software.
®
98SE, Me, 2000, and XP, and Macintosh
My Computer.
®
continue
페이지 인쇄