Cisco 500 Series 빠른 시작 Quide - 페이지 5

{카테고리_이름} Cisco 500 Series에 대한 빠른 시작 Quide을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 500 Series 13 페이지. Stackable managed switches
Cisco 500 Series에 대해서도 마찬가지입니다: 안전 정보 매뉴얼 (42 페이지), 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (21 페이지), 데이터시트 (5 페이지), 사용자 설명서 (4 페이지), 사용자 설명서 (6 페이지), 사용자 설명서 (46 페이지), 매뉴얼 (40 페이지), 관리 매뉴얼 (48 페이지), 매뉴얼 (24 페이지), 문제 해결 및 유지 관리 (15 페이지), 빠른 참조 매뉴얼 (7 페이지), 빠른 시작 매뉴얼 (25 페이지)

To mount the WAP device to a wall or ceiling:

Determine where you want to mount the device. Verify that the

TEP

surface is smooth, flat, dry, and sturdy.

Drill two pilot holes into the surface 2.75 inches (70 mm) apart for

TEP

your Cisco WAP device.

Insert a screw into each hole, leaving a gap between the surface

TEP

and the base of the screw head.

Place the upper slots of the bracket over the screws, adjust the

TEP

screws accordingly, and slide the bracket down until the screws fit

snugly into the slots.

Using the bracket as a template, drill two more holes for the lower

TEP

screws.

Insert a screw into each lower hole.

TEP

Slide the WAP device into the bracket, placing the cable through

TEP

the break-out tab found in the back of the bracket.

Connecting the Cisco WAP551 and

WAP561 Wireless-N Access Points

The default configuration of the device has the Wi-Fi radio turned off. You

must perform the initial configuration using a wired Ethernet connection. To

connect the device to the wired network:

Connect the Ethernet cable to the Ethernet port of a switch, a router,

TEP

or a PC.

Connect the other end of the network Ethernet cable to the

TEP

Ethernet port of the wireless access point.

After installation, all lights should be active. Refer to

Hardware Installation, page 6

switch.

Cisco Small Business WAP500 Series Wireless Access Point

for details about the different lights on each

Verifying the