Epson Epson Stylus NX530 수동 시작 - 페이지 2
{카테고리_이름} Epson Epson Stylus NX530에 대한 수동 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Epson Stylus NX530 4 페이지. Color inkjet all-in-one
Epson Epson Stylus NX530에 대해서도 마찬가지입니다: 설정 시트 (3 페이지), 여기에서 시작 (4 페이지)
페이지 인쇄6
Press each cartridge down until it clicks.
7
C lose the cartridge cover. Press down until it clicks. Then
lower the scanner unit and press OK.
8
W ait while the ink delivery system primes. Priming takes
about 5 minutes.
N
ote: Your printer ships with full cartridges and part of the ink from
the first cartridges is used for priming the printer.
C
aution: Don't turn off the printer while it is priming or you'll
waste ink.
9
W hen you see this menu on your product's LCD screen, do
not make a selection yet. Continue with the instructions in
the following sections to load paper in your product and
install software.
5
Load paper
1
P ull out the paper cassette at the bottom of the printer.
2
S lide the edge guides to the sides of the cassette.
3
Slide the edge guide to your paper size.
4
L oad paper against the edge guide with the glossy or
printable side facedown.
N
ote: Make sure the paper is loaded against the edge guide
and not sticking out from the end of the cassette.
5
S lide the edge guides against the edges of the paper,
but not too tightly.
6
Keep the cassette flat as you insert it.
N
ote: The paper may slide forward slightly as you insert the
cassette. This is normal.
7
E xtend the output tray and flip up the paper stopper.
N
ote: Do not flip up the paper stopper if you're using
legal-size paper.
Letter-size