Argo APOLLO 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Argo APOLLO에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo APOLLO 12 페이지. Air conditioner without outdoor unit
Argo APOLLO에 대해서도 마찬가지입니다: 서비스 매뉴얼 (17 페이지), 매뉴얼 (16 페이지)

Argo APOLLO 설치 지침 매뉴얼
2.2 - SIGNALING LEDs
6
NOTES
It is possible to set the air conditioner in order to switch OFF all LEDs, even during operation, by pressing the
LIGHT button on the remote control unit.
If the symbol
on remote control display is on, the air conditioner display will be on; if the symbol is off,
the air conditioner display will be off.
In case of troubleshooting the air conditioner diagnostic system activates the lamps accordingly, even if they
are set to OFF. See paragraph TROUBLESHOOTING for further details.
2.3 - ACCESSORIES SUPPLIED WITH THE UNIT
1. Strip of adhesive isolating tape (2pcs.)
2. Air inlet and outlet external grids including
chains and kit for installing the grids (2+2 pcs.)
3. Plastic sheet (2pcs.)
4. Wall anchoring brackets (2pcs.)
5. Operating and installation instructions
6. Paper drilling template
7. Remote control
8. Condensate discharge pipe
1. Receiver : it receives signals transmitted from the
remote control.
2. COOLING LED: This LED lights up when the air
conditioner is operating in cooling mode.
3. HEATING LED: This LED lights up when the air
conditioner is operating in heating mode.
4. DEHUMIDIFICATION LED: This LED lights up when
the air conditioner is operating in dehumidification
1
2
3
mode.
5. STANDBY LED: This LED lights up when you switch
off the air conditioner with the remote control and it
indicates also the WIFI status during unit's operation.
6. DIGITAL DISPLAY: it can display information such as
set temperature,ambient temperature, coil temperature,
status, fault code, etc.
4
5
The OFF position does not disconnect the power. Use
the main power switch to turn off power completely.
5
WARNING
1
2
3
8
4
7
6
EN
5