Cisco Aironet 1000 Series 매뉴얼 - 페이지 10

{카테고리_이름} Cisco Aironet 1000 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1000 Series 20 페이지. Install and upgrade internal modules and field replaceable units
Cisco Aironet 1000 Series에 대해서도 마찬가지입니다: 배포 매뉴얼 (40 페이지), 업그레이드 (28 페이지)

페이지 인쇄

Install an LTE Pluggable Module on a C1101-4P

Figure 5: C1118-8PLTEAP with Micro SIM Slots

This section describes how to insert a Micro-SIM card into an LTE pluggable module.

To insert the Micro-SIM cards into an LTE Pluggable module:

Note

Ensure to use the correct tool for removing the Micro-SIM door.

1. Place the pluggable module on its bottom side, remove the SIM door screw, use a #1 Philips screw driver

for removing the screws, and then carefully remove the Micro-SIM cover from the pluggable module.

Caution

Do not touch any part of the exposed PCB circuit area when the Micro-SIM cover is removed.

2. In the figure, step 2 below shows the Micro-SIM slot 1 (label 1) and Micro-SIM slot 0 (label 2).

3. Push in each Micro-SIM card (label 3) into the slot until it clicks. Secure the Micro-SIM cover with a

screw, use a number 1 Philips screw driver to secure the screw on the Micro-SIM cover. The recommended

torque is 2.8 - 3.8 inch LBF.

4. You have now successfully inserted the Micro-SIM cards into the LTE pluggable module. The marking

on the Mirco-SIM door should align with Micro-SIM0 on the pluggable module with the arrow pointing

upward.

Install and Upgrade Internal Modules and Field Replaceable Units