Cisco MeetingPlace Audio Server 5.2 업그레이드 매뉴얼 - 페이지 7
{카테고리_이름} Cisco MeetingPlace Audio Server 5.2에 대한 업그레이드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco MeetingPlace Audio Server 5.2 20 페이지. Telepresence conference system
Cisco MeetingPlace Audio Server 5.2에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지), 시작하기 매뉴얼 (46 페이지)
페이지 인쇄
Loosen the two screws holding the tape drive in the drive bay, as shown in
Step 10
Figure 5
Slowly slide out the tape drive. You should be able to slide out the tape drive such that it narrowly clears
Step 11
the bay.
If you cannot slide out the tape drive, go to the back of the server to see what is preventing the tape drive
Tip
from sliding out.
Step 12
Disconnect the power cable from the tape drive.
Remove the tape drive.
Step 13
Installing the DVD-ROM Drive into the Cisco MeetingPlace 8112
Connect one end of the IDE cable to the DVD-ROM drive. The IDE cable is keyed, as shown in
Step 1
and can only be connected one way.
Figure 6
From the front of the server, hold the DVD-ROM drive with the ejector button on the top and place the
Step 2
IDE cable, connector end first, into the drive bay.
Slide in the IDE cable into the drive bay as far as possible so that you can access the cable from the back
Step 3
of the Cisco MeetingPlace 8112.
Connect the power cable, the previous tape drive power cable, to the DVD-ROM drive.
Step 4
78-16489-01
How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM
Captive Screws on the Drive Bay
IDE Cable
Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure
Figure
5.
Figure
6,
7