Cisco MeetingPlace Audio Server 5.2 Instrukcja aktualizacji - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja aktualizacji dla System konferencyjny Cisco MeetingPlace Audio Server 5.2. Cisco MeetingPlace Audio Server 5.2 20 stron. Telepresence conference system
Również dla Cisco MeetingPlace Audio Server 5.2: Podręcznik użytkownika (44 strony), Podręcznik dla początkujących (46 strony)
Loosen the two screws holding the tape drive in the drive bay, as shown in
Step 10
Figure 5
Slowly slide out the tape drive. You should be able to slide out the tape drive such that it narrowly clears
Step 11
the bay.
If you cannot slide out the tape drive, go to the back of the server to see what is preventing the tape drive
Tip
from sliding out.
Step 12
Disconnect the power cable from the tape drive.
Remove the tape drive.
Step 13
Installing the DVD-ROM Drive into the Cisco MeetingPlace 8112
Connect one end of the IDE cable to the DVD-ROM drive. The IDE cable is keyed, as shown in
Step 1
and can only be connected one way.
Figure 6
From the front of the server, hold the DVD-ROM drive with the ejector button on the top and place the
Step 2
IDE cable, connector end first, into the drive bay.
Slide in the IDE cable into the drive bay as far as possible so that you can access the cable from the back
Step 3
of the Cisco MeetingPlace 8112.
Connect the power cable, the previous tape drive power cable, to the DVD-ROM drive.
Step 4
78-16489-01
How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM
Captive Screws on the Drive Bay
IDE Cable
Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure
Figure
5.
Figure
6,
7