Cisco Profile Series 설치 매뉴얼 - 페이지 2

{카테고리_이름} Cisco Profile Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Profile Series 16 페이지. Jbod on the 12g sas modular raid controller
Cisco Profile Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (41 페이지), 사용자 설명서 (44 페이지), 사용자 설명서 (7 페이지), 시작하기 매뉴얼 (35 페이지), 빠른 참조 매뉴얼 (2 페이지), 설치 매뉴얼 (44 페이지), 구성 매뉴얼 (13 페이지), 설치 시트 (2 페이지), 설치 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (4 페이지), 시작하기 매뉴얼 (32 페이지), 매뉴얼 (16 페이지), 시작하기 매뉴얼 (42 페이지), 시작하기 매뉴얼 (46 페이지)

페이지 인쇄
Cisco Profile Series 설치 매뉴얼
The covers are an integral part of the safety design of the product. Do not operate the unit without the
Warning
covers installed. Statement 1077
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
Warning
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, because they may cause serious injury or death. For
proper installation and grounding of the antenna, please refer to national and local codes (for
example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code,
Section 54). Statement 1052
This product is not intended to be directly connected to the Cable Distribution System. Additional
Warning
regulatory compliance and legal requirements may apply for direct connection to the Cable
Distribution System. This product may connect to the Cable Distribution System ONLY through a
device that is approved for direct connection. Statement 1078
Equipment, Tools, and Connections
This section describes the equipment, tools, and connections necessary for installing the Cisco 800M
Series ISR. It contains the following topics:
•
•
•
Items Shipped with your Router
Unpack the box and verify that all items listed on the invoice are shipped with the Cisco 800M Series
ISR.The following items are shipped with your router:
•
•
Note
The default power supply is AC. You can convert your AC power supply to DC power supply.
Note
No items are shipped with 3G Module and Console Port Module.
Connections
Obtain a broadband or Ethernet connection from your service provider.
Ethernet Devices
Identify the Ethernet devices that you connect to the router: hub, servers, and workstations or PCs.
Ensure that each device has a network interface card (NIC) for connecting to the Ethernet ports.
Cisco 800M Series Integrated Services Router Hardware Installation Guide
2-2
Items Shipped with your Router, page 2-2
Connections, page 2-2
Ethernet Devices, page 2-2
PWR CABLE - Country specific Power Cable, Max 1
PWR-30W-AC - Power Adapter

Chapter 2

Installing the Router