Cisco Profile Series 설치 매뉴얼 - 페이지 3

{카테고리_이름} Cisco Profile Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Profile Series 16 페이지. Jbod on the 12g sas modular raid controller
Cisco Profile Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (41 페이지), 사용자 설명서 (44 페이지), 사용자 설명서 (7 페이지), 시작하기 매뉴얼 (35 페이지), 빠른 참조 매뉴얼 (2 페이지), 설치 매뉴얼 (44 페이지), 구성 매뉴얼 (13 페이지), 설치 시트 (2 페이지), 설치 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (4 페이지), 시작하기 매뉴얼 (32 페이지), 매뉴얼 (16 페이지), 시작하기 매뉴얼 (42 페이지), 시작하기 매뉴얼 (46 페이지)

Chapter 2

If you plan to configure the software using Cisco IOS commands through the console port, provide an

ASCII terminal or a PC that is running terminal emulation software to connect to the console port.

If you plan to connect a modem, provide the modem and modem cable.

Installing the Router

This section describes how to install the Cisco 800M Series ISR. The Cisco 800M Series ISR can be

installed on a table top or mounted on a wall. You can choose the type of mounting while ordering the

Cisco 800M Series ISR. The recommended clearance when horizontally mounted is 1.5 inches on both

sides for floor mount bracket clearance and 2 inches on top. Top clearance is not required but stacking

heat-dissipating objects on top of the router is not allowed. Input/Output (I/O) side clearance is needed

as it is required to access the cable connections. This section also describes how to attach external

antennas to the routers and contains the following topics:

•

Warnings

This equipment needs to be grounded. Use a green and yellow 12 to 14 AWG ground wire to connect

Warning

the host to earth ground during normal use. Statement 242

This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the

Warning

absence of a suitably installed ground conductor. Contact the appropriate electrical inspection

authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024

Read the wall-mounting instructions carefully before beginning installation. Failure to use the

Warning

correct hardware or to follow the correct procedures could result in a hazardous situation to people

and damage to the system. Statement 378

Warning

Do not cover or obstruct the router vents located on both sides of the router; otherwise, overheating

could occur and cause damage to the router.

Warnings, page 2-3

Installing Antennas, page 2-10

Cisco 800M Series Integrated Services Router Hardware Installation Guide

2-3