Argo DD 설치 지침 매뉴얼 - 페이지 8

{카테고리_이름} Argo DD에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo DD 16 페이지. Air conditioner without outdoor unit

- Insert in the two holes the obtained plastic tubes.

- Fix the two anti-intrusion grilles and the two external

grilles with the blades toward the bottom using wall rawl

plugs and screws.

- In case it is not possible to fix the two external grilles

directly at the wall, hook the two grilles to the internal

ones (3) using the supplied tension bars, as follows:

a) Bend them, fix the hook of the spring, insert them

inside the tube and open them toward the outside.

b) Choose the proper hook of the tension bar in order

to lengthen the spring of 15-20 mm and hook it to

the internal grille.

c) Eliminate the exceeding part of the tension bar cutting

it near the hooking points.

- Apply the supplied gaskets (9) around the holes on the

back side of the unit.

- In case of very thin walls (less than 10 cm) it is necessary

to mount the internal anti-intrusion grilles on the back

of the unit applying the gaskets (9) around the grilles.

Unscrew the screws on the back of the unit and fix the

grilles using the same screws.

The tube and the external grilles will not be used.

CAUTION

The manufacturer assumes no

responsibilities if this safety

instruction is not observed.

INSIDE

OUTSIDE

Spring

hook