Argo DD DCI 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Argo DD DCI에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo DD DCI 16 페이지. Air conditioner without outdoor unit

2.2 - SIGNALING LAMPS

1. Receiver : it receives signals transmitted from the

remote control.

2. TIMER lamp: This lamp lights up when the air

conditioner is being controlled by the timer.

3. STANDBY lamp: This lamp lights up when the air

conditioner is waiting to start or the desired temperature

has been reached.

4. OPERATION lamp: This lamp lights up during

operation.

2.3 - ACCESSORIES SUPPLIED WITH THE UNIT

1. PLASTIC SHEET (2pcs.)

2. ExTERNAL GRILLES (2pcs.)

3. INTERNAL GRILLES (2pcs.)

4. TENSION BARS (2pcs.)

5. FULL SCALE DIAGRAM (1pcs.)

6. RAWL PLUGS + SCREWS

7. REMOTE CONTROL UNIT (1pcs.)

8. BATTERIES FOR REMOTE CONTROL (2pcs.)

9. GASKETS (4pcs.)

10. HANGING BRACKET

11. CONDENSATE DRAINAGE PIPE WITH

INSULATION

12. JUMPER FOR PCB (4pz.)

WARNING

The OFF position does not disconnect the power. Use

the main power switch to turn off power completely.

NOTES

It is possible to set the air conditioner in order to let

the OPERATION, TIMER and STANDBY lamps always

OFF, even during operation.

Press contemporary the IFEEL and FAN buttons on

the remote control unit for more then 5 seconds.

Repeat the same procedure to set again the normal

operation conditions.

In case of troubleshooting the air conditioner

diagnostic system activates the lamps accordingly,

even if they are set to OFF. See paragraph

TROUBLESHOOTING for further details.

When the air conditioner is OFF lights are off to

reduce power consumption.