Cisco Telepresence MX800 설치 매뉴얼 - 페이지 5

{카테고리_이름} Cisco Telepresence MX800에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Telepresence MX800 16 페이지. Wall-mounted mx800 single
Cisco Telepresence MX800에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지), 교체 매뉴얼 (46 페이지), 교체 매뉴얼 (47 페이지), 설치 매뉴얼 (30 페이지), 예비 부품 (24 페이지), 설치 매뉴얼 (16 페이지), 빠른 참조 매뉴얼 (2 페이지), 매뉴얼 (45 페이지), 매뉴얼 (45 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 시작하기 매뉴얼 (46 페이지)

Installation guide for Cisco TelePresence MX800 Single - Wall mount

Mount wall bracket

The lower edge of the

screen image will be

at the height of these

horizontal slots.

We recommend that

the distance from

the floor to this line is

70 cm / 27.6 in.

Check that the wall bracket is level and mark the required

screw hole positions on the wall. Use at least four screws

when fastening the wall bracket. The wall bracket can be

fastened through any of the horizontal slots.

Fasten the wall bracket in a secure manner ensuring that the

wall's structure is sufficient to support the system load (screws

and mounting hardware not provided; not shown in illustration).

If you mount the system higher, note the following consequences:

- You may need to increase the distance between the video system and the

table in order for the camera to capture the closest participants.

- The camera will give an elevated view of the room. This view is not optimal

for video conferencing.

Further information:

http://www.cisco.com/go/projectworkplace

2D CAD drawings with measurements:

http://www.cisco.com/go/mx-docs

(Technical References)

Page 5