Cisco TelePresence SpeakerTrack 60 카메라 매뉴얼 - 페이지 32
{카테고리_이름} Cisco TelePresence SpeakerTrack 60에 대한 카메라 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence SpeakerTrack 60 40 페이지. Telepresence
Cisco TelePresence SpeakerTrack 60에 대해서도 마찬가지입니다: 데이터시트 (3 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (14 페이지), 매뉴얼 (22 페이지), 카메라 매뉴얼 (44 페이지)
페이지 인쇄
Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
Contents
SpeakerTrack 60 Camera
Factory resetting the device
A factory reset should only be performed by a system
administrator or in contact with Cisco technical support.
The device will be reset to factory defaults, and all configu-
ration and logs will be erased.
If errors continue to occur, the cameras might have to be
reset too. See the next page for instructions on how to
reset the cameras.
REMOVE COVER
REMOVE COVER
It is not possible to undo a factory reset.
To perform a factory reset:
1. Unplug the power.
2. Remove the top cover of the SpeakerTrack 60 device.
3. Locate the pinhole button at the top of the SpeakerTrack
60.
4. Use a pen or similar to press and hold the factory reset
button for 5 seconds while plugging the power back in.
5. When the factory reset is complete, the device restarts
and the LED lights up.
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Introduction
Physical interface
Connecting to a codec
1
REMOVE COVER
REMOVE COVER
2
3
32
Factory reset
Factory reset
Appendix
Pinhole for
factory reset
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
Camera guide