Sony BRC-X400 명령 목록 - 페이지 7
{카테고리_이름} Sony BRC-X400에 대한 명령 목록을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony BRC-X400 41 페이지. Srt introduction
Sony BRC-X400에 대해서도 마찬가지입니다: 매뉴얼 (15 페이지), 기술 매뉴얼 (15 페이지)
페이지 인쇄
VISCA Command/ACK Protocol
Command
Command
Message
General
81 01 04 38 02 FF
Command
(Example)
81 01 04 38 FF
(Example)
81 01 04 38 02 FF
(Example)
81 01 04 08 02 FF
(Example)
Inquiry
81 09 04 38 FF
Command
(Example)
81 09 05 38 FF
(Example)
*
Address Set
88 30 01 FF
IF_Clear
88 01 00 01 FF
*
(Broadcast)
IF_Clear (For x)
8x 01 00 01 FF
Command Cancel 8x 2p FF
* Not available for VISCA over IP.
Do not transmit the command (except Address Set, IF_Clear, Command Cancel and CAMERA POWER
SUPPLY (page 21)) when any menu is displayed on the screen. If displayed, clear the menu first using
MENU (page 21) Command, and then proceed.
Reply Message
Comments
90 4z FF (ACK) , 90 5z
Returns ACK when a command has been accepted,
FF (Completion)
or Completion when a command has been executed.
(z: Socket No.)
90 60 02 FF
Accepted a command which is not supported or a
(Syntax Error)
command lacking parameters.
90 60 03 FF
Could not accept the command as there are two
(Command Buffer Full)
commands currently being executed.
90 6z 41 FF
Could not execute the command in the current
(Command Not
mode.
Executable)
(z: Socket No.)
90 50 02 FF
Does not return ACK for the Inquiry Command.
(Completion)
90 60 02 FF
Accepted an incompatible command.
(Syntax Error)
88 30 02 FF
Always broadcasted. The device address number
plus 1 is returned.
88 01 00 01 FF
The same command is returned.
y0 50 FF (Completion)
ACK is not returned for this command.
y0 6p 04 FF
Returned when the command of the specified socket
(Command Canceled)
is cancelled. Completion for the command cancelled
is not returned.
y0 6p 05 FF
Returned when the command of the specified socket
(No Socket)
has already been completed or when the specified
socket number is wrong.
7