Cisco TelePresence System C20 Plus 시작하기 매뉴얼 - 페이지 26
{카테고리_이름} Cisco TelePresence System C20 Plus에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence System C20 Plus 35 페이지. Telepresence conference system
Cisco TelePresence System C20 Plus에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지), 시작하기 매뉴얼 (32 페이지), 시작하기 매뉴얼 (46 페이지)
페이지 인쇄
Cisco TelePresence Systems
GettinG started Guide
Table of contents
Introduction
Web interface
Using the web interface for system configuration
You have to use the Touch controller or remote control for
the configurations until you know your system's IP address.
Finding the IP address
Tap
More > Settings > System Information
controller; or navigate to
Home > Settings > System
information
if you use the remote control and on‑screen
menu.
In both cases you will find the IPv4 Address and/or IPv6
Address of the system in the NETWORK section on this
System Information page.
Signing in to the web interface
1. Open a web browser and enter the system's IP address
in the address bar.
2. Enter your user name and password and click
The default user name is
admin
with no password set.
If you are not able to connect to the system:
• Make sure the system and computer are connected to
the same network.
• Make sure the system is switched on.
If the system has just been switched on, wait a few minutes
to allow the system to start up.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces
on a Touch
Sign
In.
Configuration
Configuration
Appendices
The web interface
26
www.cisco.com