Cisco 2100 Series 빠른 시작 매뉴얼 - 페이지 17

{카테고리_이름} Cisco 2100 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2100 Series 49 페이지. Cisco 8500 series wireless lan controller
Cisco 2100 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (40 페이지), 구성 매뉴얼 (50 페이지), 빠른 시작 매뉴얼 (12 페이지)

페이지 인쇄

The CLI displays the root level system prompt:

Step 2

#(system prompt)>

The system prompt can be any alphanumeric string up to 31 characters. You can change it by

entering the config prompt command. For example, to change the system prompt to Cisco

2112, enter config prompt "Cisco 2112" and press Enter. Make sure you enter the new

prompt using double quotation marks.

The CLI automatically logs out without saving any changes after 5 minutes of

Note

inactivity. You can set the automatic logout from 0 (never log out) to 160 minutes

using the config serial timeout command.

Connecting the Network

Figure 4 shows the connection from the network (802.11 distribution system) to the controller. The

connection uses 10/100BASE-T Ethernet (RJ-45 physical port, UTP, Category-5 or higher cable).

Always use Category-5, Category-5e, Category-6, or Category-7 Ethernet cables to connect the office

network equipment to the controller.

Figure 4

External Network Equipment Connection to the Controller

Network

Connection to

main office

Firewall

Office

network

10/100BASE-T

CLI console

10/100BASE-T

MDI cable

Cisco Access Points