Cisco 2691 Series 설치 및 포맷 - 페이지 9

{카테고리_이름} Cisco 2691 Series에 대한 설치 및 포맷을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2691 Series 34 페이지. Modular routers
Cisco 2691 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 사용자 설명서 (48 페이지), 빠른 시작 매뉴얼 (29 페이지)

페이지 인쇄

March 2002

Figure 9

Removing the Chassis Cover

This section describes how to remove the chassis cover to access internally mounted CompactFlash

memory cards. You need a number 2 Phillips or flat-blade screwdriver to complete this procedure.

You must remove the chassis cover from Cisco 2691, Cisco 3631, and Cisco 3725 routers.

Observe the following precaution if your router uses AC or DC power:

Warning

Do not touch the power supply when the power cord is connected. For systems with a power

switch, line voltages are present within the power supply even when the power switch is OFF and

the power cord is connected. For systems without a power switch, line voltages are present within

the power supply when the power cord is connected. To see translations of the various warnings

that appear in this publication, refer to the Regulatory Compliance and Safety Information

document that accompanied this device.

Observe the following precaution if your router uses DC power:

Warning

Before performing any of the following procedures, ensure that power is removed from the DC

circuit. To ensure that all power is OFF, locate the circuit breaker on the panel board that services

the DC circuit, switch the circuit breaker to the OFF position, and tape the switch handle of the

circuit breaker in the OFF position. To see translations of the various warnings that appear in this

publication, refer to the Regulatory Compliance and Safety Information document that

accompanied this device.

78-13892-03

Removing the CPU/Mainboard from a Cisco 3745 Router

Captive

retention

screw

Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards

Internal CompactFlash Memory Card Installation and Removal

Ejector levers

Captive

retention

screw