Cisco 2691 Series 설치 및 포맷 - 페이지 10

{카테고리_이름} Cisco 2691 Series에 대한 설치 및 포맷을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2691 Series 34 페이지. Modular routers
Cisco 2691 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 사용자 설명서 (48 페이지), 빠른 시작 매뉴얼 (29 페이지)

페이지 인쇄

Internal CompactFlash Memory Card Installation and Removal

Complete the following procedure to remove the chassis cover:

Power OFF the router. However, to channel ESD voltages to ground, do not unplug the power cable.

Step 1

Warning

Before opening the chassis, disconnect the telephone-network cables to avoid contact with

telephone-network voltages. To see translations of the various warnings that appear in this

publication, refer to the Regulatory Compliance and Safety Information document that

accompanied this device.

Step 2

Disconnect all network interface cables from the rear panel.

Step 3

Place the router on a flat surface. Remove the screws located on top of the cover (five screws on a

Cisco 2691 or Cisco 3631 router; six screws on a Cisco 3725 router). Set the screws aside in a safe

place.

Rotate the cover up to a 45-degree angle. (See

Step 4

Slide the cover to the side (away from the side with the fans) until the tabs are free from the slots. (See

Step 5

Figure

To replace the cover, see the

Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards

10,

Figure

11, or

Figure

12.)

"Reinstalling the Cover on a Cisco Router" section on page

Figure

10,

Figure

11, or

Figure

March 2002

12.)

16.

78-13892-03