Cisco 2691 Series Встановлення та форматування - Сторінка 10

Переглянути онлайн або завантажити pdf Встановлення та форматування для Мережеве обладнання Cisco 2691 Series. Cisco 2691 Series 34 сторінки. Modular routers
Також для Cisco 2691 Series: Технічний паспорт (8 сторінок), Посібник користувача (48 сторінок), Посібник із швидкого старту (29 сторінок)

Internal CompactFlash Memory Card Installation and Removal

Complete the following procedure to remove the chassis cover:

Power OFF the router. However, to channel ESD voltages to ground, do not unplug the power cable.

Step 1

Warning

Before opening the chassis, disconnect the telephone-network cables to avoid contact with

telephone-network voltages. To see translations of the various warnings that appear in this

publication, refer to the Regulatory Compliance and Safety Information document that

accompanied this device.

Step 2

Disconnect all network interface cables from the rear panel.

Step 3

Place the router on a flat surface. Remove the screws located on top of the cover (five screws on a

Cisco 2691 or Cisco 3631 router; six screws on a Cisco 3725 router). Set the screws aside in a safe

place.

Rotate the cover up to a 45-degree angle. (See

Step 4

Slide the cover to the side (away from the side with the fans) until the tabs are free from the slots. (See

Step 5

Figure

To replace the cover, see the

Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards

10,

Figure

11, or

Figure

12.)

"Reinstalling the Cover on a Cisco Router" section on page

Figure

10,

Figure

11, or

Figure

March 2002

12.)

16.

78-13892-03