Cisco 2691 Series Yükleme ve Biçimlendirme - Sayfa 10
Ağ Donanımı Cisco 2691 Series için çevrimiçi göz atın veya pdf Yükleme ve Biçimlendirme indirin. Cisco 2691 Series 34 sayfaları. Modular routers
Ayrıca Cisco 2691 Series için: Veri Sayfası (8 sayfalar), Kullanıcı Kılavuzu (48 sayfalar), Hızlı Başlangıç Kılavuzu (29 sayfalar)
Sayfayı Yazdır
Internal CompactFlash Memory Card Installation and Removal
Complete the following procedure to remove the chassis cover:
Power OFF the router. However, to channel ESD voltages to ground, do not unplug the power cable.
Step 1
Warning
Before opening the chassis, disconnect the telephone-network cables to avoid contact with
telephone-network voltages. To see translations of the various warnings that appear in this
publication, refer to the Regulatory Compliance and Safety Information document that
accompanied this device.
Step 2
Disconnect all network interface cables from the rear panel.
Step 3
Place the router on a flat surface. Remove the screws located on top of the cover (five screws on a
Cisco 2691 or Cisco 3631 router; six screws on a Cisco 3725 router). Set the screws aside in a safe
place.
Rotate the cover up to a 45-degree angle. (See
Step 4
Slide the cover to the side (away from the side with the fans) until the tabs are free from the slots. (See
Step 5
Figure
To replace the cover, see the
Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards
10
10,
Figure
11, or
Figure
12.)
"Reinstalling the Cover on a Cisco Router" section on page
Figure
10,
Figure
11, or
Figure
March 2002
12.)
16.
78-13892-03