Cisco 3020 - Cisco Catalyst Blade Switch 시작하기 매뉴얼 - 페이지 17

{카테고리_이름} Cisco 3020 - Cisco Catalyst Blade Switch에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3020 - Cisco Catalyst Blade Switch 31 페이지. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Cisco 3020 - Cisco Catalyst Blade Switch에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (37 페이지), 빠른 사양 (12 페이지), 릴리스 노트 (41 페이지), 릴리스 노트 (27 페이지), 릴리스 노트 (23 페이지), 릴리스 노트 (21 페이지), 설치 매뉴얼 (21 페이지)

페이지 인쇄
Cisco 3020 - Cisco Catalyst Blade Switch 시작하기 매뉴얼
Figure 8
Advanced Settings Tab
In the Host Name field, enter a name for the switch module. The host name is limited to
Step 2
31 characters; embedded spaces are not allowed.
In the System Date and System Time fields, enter the current date and time, or use the down
Step 3
arrows to select them.
In the Time Zone field, use the down arrow to choose your time zone.
Step 4
Click Enable in the Daylight Savings Time field to enable this feature.
Step 5
In the Telnet Access field, click Enable if you are going to use Telnet to manage the switch
Step 6
module by using the CLI. If you enable Telnet access, you must enter a Telnet password.
If you plan to create a switch stack, enable Telnet access so that you can use the CLI
Note
to set this switch to the highest priority. See the "Planning and Creating a Switch
Stack (Only the Cisco Catalyst Blade Switch 3120 for HP)" section on page 23 for
more information about creating a switch stack.
In the Telnet Password field, enter a password. The Telnet password can be from 1 to 25
Step 7
alphanumeric characters, is case sensitive, allows embedded spaces, but does not allow spaces
at the beginning or end. In the Confirm Telnet Password field, re-enter the Telnet password.
Step 8
In the SNMP field, click Enable to enable Simple Network Management Protocol (SNMP).
Enable SNMP only if you plan to manage switches by using CiscoWorks 2000 or another
SNMP-based network-management system.
17