Cisco 3020 - Cisco Catalyst Blade Switch Руководство по началу работы - Страница 17

Просмотреть онлайн или скачать pdf Руководство по началу работы для Сетевое оборудование Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 31 страница. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Также для Cisco 3020 - Cisco Catalyst Blade Switch: Руководство по началу работы (37 страниц), Quickspecs (12 страниц), Примечание к выпуску (41 страниц), Примечание к выпуску (27 страниц), Примечание к выпуску (23 страниц), Примечание к выпуску (21 страниц), Руководство по установке (21 страниц)

Figure 8

Advanced Settings Tab

In the Host Name field, enter a name for the switch module. The host name is limited to

Step 2

31 characters; embedded spaces are not allowed.

In the System Date and System Time fields, enter the current date and time, or use the down

Step 3

arrows to select them.

In the Time Zone field, use the down arrow to choose your time zone.

Step 4

Click Enable in the Daylight Savings Time field to enable this feature.

Step 5

In the Telnet Access field, click Enable if you are going to use Telnet to manage the switch

Step 6

module by using the CLI. If you enable Telnet access, you must enter a Telnet password.

If you plan to create a switch stack, enable Telnet access so that you can use the CLI

Note

to set this switch to the highest priority. See the "Planning and Creating a Switch

Stack (Only the Cisco Catalyst Blade Switch 3120 for HP)" section on page 23 for

more information about creating a switch stack.

In the Telnet Password field, enter a password. The Telnet password can be from 1 to 25

Step 7

alphanumeric characters, is case sensitive, allows embedded spaces, but does not allow spaces

at the beginning or end. In the Confirm Telnet Password field, re-enter the Telnet password.

Step 8

In the SNMP field, click Enable to enable Simple Network Management Protocol (SNMP).

Enable SNMP only if you plan to manage switches by using CiscoWorks 2000 or another

SNMP-based network-management system.