Cisco 3110 매뉴얼 - 페이지 13
{카테고리_이름} Cisco 3110에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3110 42 페이지.
Cisco 3110에 대해서도 마찬가지입니다: 시작하기 (42 페이지)
페이지 인쇄
Overview
9
11
13
Rear Panel
The following figure shows the rear panel of the Secure Firewall 3100.
SSD 1 Status
• Off—The SSD is not present.
• Green—The SSD is present; no activity.
• Green, flashing—The SSD is active.
• Amber—The SSD has a problem or failure.
SSD 2 Status
• Off—The SSD is not present.
• Green—The SSD is present; no activity.
• Green, flashing—The SSD is active.
• Amber—The SSD has a problem or failure.
Activity Status (Role of a high-availability pair)
• Off—The unit is not configured or enabled
in a high-availability pair.
• Green—The unit is in active mode.
• Amber—The unit is in standby mode.
10
System Status
• Off—System has not booted up yet.
• Green, flashing quickly—System is booting
up.
• Green—Normal system function.
• Amber—System boot up has failed.
• Amber, flashing—Alarm condition, system
needs service or attention and may not boot
properly.
12
Power Status
• Off—Input power is not detected. If the AC
power cord is plugged in, and the LED on
the power supply is blinking green, standby
power is still on.
• Green, flashing—The system has detected
a power switch toggle event, and initiated
the shutdown sequence. If the power switch
is in the OFF position, the system powers
off after shutdown is completed. Do not
remove the AC or DC power source while
this LED is blinking so that the system has
time to perform a graceful shutdown.
• Amber—The system is powering up (before
the BIOS boots). This takes one to five
seconds at most.
• Green—The system is fully powered up.
—
Rear Panel
Overview
13