Cisco 3110 매뉴얼 - 페이지 20

{카테고리_이름} Cisco 3110에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3110 42 페이지.
Cisco 3110에 대해서도 마찬가지입니다: 시작하기 (42 페이지)

8-Port 10/100/1000Base-T Network Module with Hardware Bypass

Note

The hardware and the system support hot swapping if you are replacing a network module with the same type

of network module. If you replace the 8-port 10/100/1000Base-T network module with another supported

network module, you must reboot the chassis so that the new network module is recognized. See the

configuration guide for your operating system for the detailed procedures for managing network modules.

Note

Make sure you have the correct firmware package and software version installed to support this network

module. See the configuration guide for your software for the procedures for updating the firmware package

and verifying the software version. See the

the

Cisco Secure Firewall ASA Compatibility

including operating system and hosting environment requirements, for each supported version.

The following figure shows the front panel of the 8-port 10/100/1000Base-Tnetwork module.

Figure 10: 8-Port 10/100/1000Base-T Network Module (FPR-X-NM-8X1GF)

Bypass LEDs B1 through B4

• Green—In standby mode.

• Amber, flashing—Port is in hardware bypass

Overview

mode, failure event.

Cisco Secure Firewall Threat Defense Compatibility Guide

guide, which provide Cisco software and hardware compatibility,

Ethernet 2/1 and Ethernet 2/2

Ports 1 and 2 are paired together to form a

hardware bypass pair. LED B1 applies to this

paired port.

Overview

and