Cisco 3110 매뉴얼 - 페이지 9

{카테고리_이름} Cisco 3110에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3110 42 페이지.
Cisco 3110에 대해서도 마찬가지입니다: 시작하기 (42 페이지)

Overview

Figure 5: Secure Firewall 3100 Front Panel

SSD-1

System LEDs

Type A USB 3.1 port

Reset button LED

Pullout asset card with chassis serial number,

getting started guide QR code, and LTP QR code

Fixed fiber ports (NM-1)

Fiber ports named 1/9 through 1/16 left to right

Management Port

The Secure Firewall 3100 chassis management port is a 1/10-Gb fiber SFP port.

RJ-45 Console Port

The Secure Firewall 3100 chassis has a standard RJ-45 console port. You can use the CLI to configure

your 3100 through the RJ-45 serial console port by using a terminal server or a terminal emulation

program on a computer.

The RJ-45 (8P8C) port supports RS-232 signaling to an internal UART controller. The console port does

not have any hardware flow control, and does not support a remote dial-in modem. The baud rate is 9600.

You can use the standard cable found in your accessory kit to convert the RJ-45 to DB-9 if necessary.

Type A USB 3.1 Port

You can use the external Type A USB port to attach a data-storage device. The external USB drive

identifier is

. The Type A USB port supports the following:

usb:

• Hot swapping

SSD-2

RJ-45 console port

Gigabit Ethernet management port:

• Secure Firewall Threat

Defense—Management 0 (also referred to

as Management 1/1 and Diagnostic 1/1)

• ASA—Management 1/1

Recessed factory reset button

Fixed copper ports (NM-1)

Copper ports named 1/1 through 1/8 left to right

Network module (NM-2)

Front Panel

Overview