Cisco 3140 시작하기 - 페이지 30

{카테고리_이름} Cisco 3140에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3140 42 페이지.
Cisco 3140에 대해서도 마찬가지입니다: 매뉴얼 (42 페이지)

페이지 인쇄

Configuration After Initial Setup

Setting

Management access through

data interfaces.

System time.

Smart license.

Inside interface IP address.

DHCP server for inside clients.

DHCP auto-configuration for

inside clients.

(Auto-configuration supplies

clients with addresses for WINS

and DNS servers.)

Getting Started

Configuration

A data interface management access list rule allows HTTPS access

through the inside interface. SSH connections are not allowed.

Both IPv4 and IPv6 connections are allowed.

Firepower 4100/9300: No data interfaces have default

management access rules.

ISA 3000: No data interfaces have default management access

rules.

FTDv: No data interfaces have default management access rules.

The time zone and NTP servers you selected.

Firepower 4100/9300: System time is inherited from the chassis.

ISA 3000: Cisco NTP servers: 0.sourcefire.pool.ntp.org,

1.sourcefire.pool.ntp.org, 2.sourcefire.pool.ntp.org.

Either registered with a base license, or the evaluation period

activated, whichever you selected.

Subscription licenses are not enabled. Go to the smart licensing

page to enable them.

192.168.95.1/24

Firepower 4100/9300: Data interfaces are not pre-configured.

ISA 3000: None. You must set the BVI1 IP address manually.

FTDv: 192.168.45.1/24

Running on the inside interface with the address pool 192.168.95.5

- 192.168.95.254.

Firepower 4100/9300: No DHCP server enabled.

ISA 3000: No DHCP server enabled.

FTDv: The address pool on the inside interface is 192.168.45.46

- 192.168.45.254.

Enabled on outside interface if you use DHCP to obtain the outside

interface IPv4 address.

If you use static addressing, DHCP auto-configuration is disabled.

Getting Started

Explicit, implied, or default

configuration

Implied.

Explicit.

Default.

Explicit, but indirectly.