Sony XCGH280CR 기술 매뉴얼 - 페이지 21

{카테고리_이름} Sony XCGH280CR에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony XCGH280CR 46 페이지. Digital video camera module
Sony XCGH280CR에 대해서도 마찬가지입니다: 브로셔 (2 페이지)

페이지 인쇄

Line Inverter

You can inverse the signal to be output to GPO.

Setting parameter: LineInverter[LineSelector] = True/

Line Sources

The signals mentioned below can be selected for the

output from the GPO ports.

If the line inverter is set to "False," all signals are High

Active.

Trigger Through output

The signal supplied to the trigger input connector

selected with "TriggerSource" is output as-is.

Setting parameter: LineSource[LineSelector] =

Exposure output

For outputting the exposure time of the image sensor.

Setting parameter: LineSource[LineSelector] =

Sensor ReadOut output

For outputting the status of reading from the image

sensor.

Setting parameter: LineSource[LineSelector] =

Strobe control outputs

For fine adjustment of strobe control for external devices

connected to the camera by controlling the timing and

width of signal generation.

The strobe delay and width can be set each for the GPO1

and GPO2 ports.

Setting parameters: LineSource[LineSelector] =

StrobeActiveTime[LineSelector] =

StrobeActiveDelay[LineSelector] =

Note

When using strobe control output, if the strobe delay or

strobe width exceeds the exposure interval, proper

strobe signals cannot be output. Set the strobe control

output so that the delay and width are within the

exposure time.

User outputs

For outputting the user-specified True/False setting.

The camera provides two user output settings (User

Output 1 and User Output 2) which can be selected each

for GPO1 and GPO2 port.

Setting parameters: LineSource[LineSelector] =

For More Information Please Call Aegis Electronic Group, Inc. * (888) 687-6877 Phone * [email protected] * http://www.aegis-elec.com

False

TriggerSignalThroughOut

ExposureActive

SensorReadOutActive

StrobeActive

1 to 4000 (us)

0 to 4000 (us)

UserOutput1/UserOutput2

UserOutputSelector =

UserOutput1/UserOutput2

UserOutputValue[UserOutputSelec

tor] = True/False

True/False

For outputting the True/False setting.

Settting parameter: LineSource = True/False

Line Status

"True" is returned if the input to the selected GPI port is

High, and "False" is returned if it is Low.

Observation parameter: LineStatus[LineSelector] =

True/False