Cisco 5400 Series 설치 - 페이지 2

{카테고리_이름} Cisco 5400 Series에 대한 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 5400 Series 6 페이지. Enterprise network compute system

Installing the Cisco 5400 ENCS

Figure 1: Label Tray

Installing the Cisco 5400 ENCS

If it is not already installed, the DIMMs, M.2 storage module and RAID card must be installed before

rack-mounting or wall-mounting the chassis. We recommend that you install the power supply when you have

the best access to the back panel of the device; this could be before or after you mount the device. You can

install the NIM and HDDs either before or after you mount the chassis.

Rack-Mounting the Chassis

The Cisco 5400 ENCS can be installed in 19-inch (48.26-cm) racks. Use the standard brackets shipped with

the router for mounting the chassis in a 19-inch EIA rack.

You can mount the device in the following ways:

• Front mounting—Brackets attached at the front of the chassis with the front panel facing forward

• Back mounting—Brackets attached at the back of the chassis with the back panel facing forward

• Center-front mounting—Brackets attached in the center front of the chassis with the front panel facing

• Center-back mounting—Brackets attached in the center back of the chassis with the back panel facing

Attaching Brackets to the Chassis

Attach one mounting bracket to each side of the device as shown in Figures 6 and 7. You will need four screws

to attach each bracket to the device; so, you will need eight screws in total to attach both the brackets to the

device. Use the screws provided along with the mounting kit to attach the screws to the device.

Installing the Device

Product ID

PID/VID

forward

Serial Number

CLEI

Installing the Device