Cisco 5400 Series Installation von - Seite 2
Blättern Sie online oder laden Sie pdf Installation von für Netzwerk-Hardware Cisco 5400 Series herunter. Cisco 5400 Series 6 Seiten. Enterprise network compute system
Seite drucken
Installing the Cisco 5400 ENCS
Figure 1: Label Tray
1
3
Installing the Cisco 5400 ENCS
If it is not already installed, the DIMMs, M.2 storage module and RAID card must be installed before
rack-mounting or wall-mounting the chassis. We recommend that you install the power supply when you have
the best access to the back panel of the device; this could be before or after you mount the device. You can
install the NIM and HDDs either before or after you mount the chassis.
Rack-Mounting the Chassis
The Cisco 5400 ENCS can be installed in 19-inch (48.26-cm) racks. Use the standard brackets shipped with
the router for mounting the chassis in a 19-inch EIA rack.
You can mount the device in the following ways:
• Front mounting—Brackets attached at the front of the chassis with the front panel facing forward
• Back mounting—Brackets attached at the back of the chassis with the back panel facing forward
• Center-front mounting—Brackets attached in the center front of the chassis with the front panel facing
• Center-back mounting—Brackets attached in the center back of the chassis with the back panel facing
Attaching Brackets to the Chassis
Attach one mounting bracket to each side of the device as shown in Figures 6 and 7. You will need four screws
to attach each bracket to the device; so, you will need eight screws in total to attach both the brackets to the
device. Use the screws provided along with the mounting kit to attach the screws to the device.
Installing the Device
2
Product ID
PID/VID
forward
forward
2
Serial Number
4
CLEI
Installing the Device