Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 설치 참고 사항 - 페이지 10

{카테고리_이름} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 36 페이지. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대해서도 마찬가지입니다: 설치 참고 사항 (14 페이지), 솔루션 매뉴얼 (17 페이지), 설치 참고 사항 (46 페이지), 백서 (19 페이지), 설명 (1 페이지), 제품 게시판 (6 페이지), 공지 사항 (4 페이지), 데이터시트 (9 페이지), 데이터시트 (18 페이지), 백서 (18 페이지), 구성 매뉴얼 (8 페이지), 설치 참고 사항 (28 페이지), 문제 해결 매뉴얼 (11 페이지), 설치 참고 사항 (18 페이지), 사용자 설명서 (17 페이지), 설치 참고 사항 (24 페이지), 매뉴얼 (19 페이지)

Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 설치 참고 사항

Removing a CFC or DFC3 Daughter Card

Removing a CFC or DFC3 Daughter Card
If you are upgrading one of the WS-X67xx Ethernet modules listed in
card, you must remove the CFC or the DFC3 daughter card before installing the new DFC4 daughter
card. The following two procedures are provided:
Once you have replaced the DFC3 daughter card with a DFC4 daughter card, the module will only
Note
operate with the Supervisor Engine 2T.
Removing the CFC Daughter Card
If your WS-X67xx Ethernet module is equipped with a CFC daughter card, you must remove it before
you install the DFC4 daughter card.
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
To remove a CFC daughter card, follow these steps:
Attach an ESD grounding strap to your wrist and to ground.
Step 1
Remove the Ethernet module from the Catalyst 6500 series switch.
Step 2
If you are unsure about the correct procedure for removing a module from the switch chassis, refer to
the
instructions.
Place the Ethernet module on an antistatic mat with the front of the module facing toward you.
Step 3
Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note
10
Removing the CFC Daughter Card, page 10
Removing the DFC3 Daughter Card, page 14
"Removing and Installing Ethernet Modules in the Chassis" section on page 28
Table 2
with a DFC4 daughter
for removal
OL-24918-02