Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Note d'installation - Page 10

Parcourez en ligne ou téléchargez le pdf Note d'installation pour {nom_de_la_catégorie} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 36 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Également pour Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion : Note d'installation (14 pages), Manuel de solution (17 pages), Note d'installation (46 pages), Livre blanc (19 pages), Description (1 pages), Bulletin d'information sur les produits (6 pages), Avis (4 pages), Fiche technique (9 pages), Fiche technique (18 pages), Livre blanc (18 pages), Manuel de configuration (8 pages), Note d'installation (28 pages), Manuel de dépannage (11 pages), Note d'installation (18 pages), Manuel de l'utilisateur (17 pages), Note d'installation (24 pages), Manuel (19 pages)

Removing a CFC or DFC3 Daughter Card

If you are upgrading one of the WS-X67xx Ethernet modules listed in

card, you must remove the CFC or the DFC3 daughter card before installing the new DFC4 daughter

card. The following two procedures are provided:

•

Once you have replaced the DFC3 daughter card with a DFC4 daughter card, the module will only

Note

operate with the Supervisor Engine 2T.

Removing the CFC Daughter Card

If your WS-X67xx Ethernet module is equipped with a CFC daughter card, you must remove it before

you install the DFC4 daughter card.

Warning

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly

touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94

To remove a CFC daughter card, follow these steps:

Attach an ESD grounding strap to your wrist and to ground.

Step 1

Remove the Ethernet module from the Catalyst 6500 series switch.

Step 2

If you are unsure about the correct procedure for removing a module from the switch chassis, refer to

the

instructions.

Place the Ethernet module on an antistatic mat with the front of the module facing toward you.

Step 3

Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note

Removing the CFC Daughter Card, page 10

Removing the DFC3 Daughter Card, page 14

"Removing and Installing Ethernet Modules in the Chassis" section on page 28

Table 2

with a DFC4 daughter

for removal

OL-24918-02