Cisco 7505 빠른 시작 매뉴얼 - 페이지 27

{카테고리_이름} Cisco 7505에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7505 32 페이지. 600w ac-input power supply and fan tray replacement
Cisco 7505에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (23 페이지), 설치 지침 매뉴얼 (15 페이지), 교체 지침 매뉴얼 (18 페이지)

페이지 인쇄

Install Field Replaceable Units (FRUs)

Remove and Install Port Adapters

Screw

Carrier

Lower edge

Captive

installation

screw

Note

removing the port adapter from the VIP. See the

"Remove and Install an Interface Processor, Filler,

VIP, or RSP" section on page 18 for instructions.

Step 1

Step 2

Step 3

Step 4

Step 5

Upper edge

Step 6

First remove the VIP from the chassis before

Remove the screw that secures the port

adapter (or blank port adapter), as shown

in A.

Grasp the handle and carefully pull it out

of its slot, away from the edge connector

at the rear of the slot. (See A.)

To insert the port adapter, align the carrier

between the upper and the lower edges of

the port adapter slot. (See B.)

Carefully slide the port adapter into the

slot until the connector is completely

seated in the connector at the rear of the

port adapter slot, as shown in B.

Install the screw in the rear of the port

adapter slot on the VIP. Do not

overtighten the screw. (See A.)

Carefully slide the VIP motherboard into

the interface processor slot until the

connectors at the rear of the VIP are

completely seated in the connectors at the

rear of the interface processor slot. Use the

ejector levers to seat the VIP in the

interface processor slot. Tighten the

captive installation screws on the VIP.

(See C.)