Cisco 7505 Посібник із швидкого старту - Сторінка 27

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережеве обладнання Cisco 7505. Cisco 7505 32 сторінки. 600w ac-input power supply and fan tray replacement
Також для Cisco 7505: Інструкція із заміни Посібник із заміни (23 сторінок), Інструкція з монтажу Посібник з монтажу (15 сторінок), Інструкція із заміни Посібник із заміни (18 сторінок)

Install Field Replaceable Units (FRUs)

Remove and Install Port Adapters

Screw

Carrier

Lower edge

Captive

installation

screw

Note

removing the port adapter from the VIP. See the

"Remove and Install an Interface Processor, Filler,

VIP, or RSP" section on page 18 for instructions.

Step 1

Step 2

Step 3

Step 4

Step 5

Upper edge

Step 6

First remove the VIP from the chassis before

Remove the screw that secures the port

adapter (or blank port adapter), as shown

in A.

Grasp the handle and carefully pull it out

of its slot, away from the edge connector

at the rear of the slot. (See A.)

To insert the port adapter, align the carrier

between the upper and the lower edges of

the port adapter slot. (See B.)

Carefully slide the port adapter into the

slot until the connector is completely

seated in the connector at the rear of the

port adapter slot, as shown in B.

Install the screw in the rear of the port

adapter slot on the VIP. Do not

overtighten the screw. (See A.)

Carefully slide the VIP motherboard into

the interface processor slot until the

connectors at the rear of the VIP are

completely seated in the connectors at the

rear of the interface processor slot. Use the

ejector levers to seat the VIP in the

interface processor slot. Tighten the

captive installation screws on the VIP.

(See C.)