Cisco 7513 Series 빠른 시작 매뉴얼 - 페이지 23

{카테고리_이름} Cisco 7513 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 44 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 매뉴얼 (30 페이지), 유지 관리 (20 페이지), 교체 지침 매뉴얼 (19 페이지), 교체 지침 매뉴얼 (22 페이지)

페이지 인쇄

Step 2

Determine which protocols you want to allow on the synchronous serial interface and enter the

appropriate responses:

Configure IP unnumbered on this interface? [no]:

IP address for this interface: 1.1.1.20

Number of bits in subnet field [0]:

Class A network is 1.0.0.0, 0 subnet bits;

mask is 255.0.0.0

Configure IPX on this interface? [no]: yes

IPX network number [2]:

Configure AppleTalk on this interface? [no]:

yes

Extended AppleTalk network? [no]:

AppleTalk network number [1]:

Step 3

Press Ctrl-Z to exit conﬁguration mode.

Step 4

At the # prompt, enter the copy

running-conﬁg startup-conﬁg command

to save the conﬁguration to NVRAM as

follows:

Hostname# copy running-config startup-config

Your Cisco 7507 router is now minimally conﬁgured

and ready to use. If you want to modify the

parameters after the initial conﬁguration, use the

setup command. To perform more complex

conﬁgurations, use the conﬁgure command. For

more information on additional interface

conﬁguration and information on more speciﬁc

system conﬁgurations, refer to the Cisco 7500 Series

Installation and Conﬁguration Guide.