Cisco 7513 Series 빠른 시작 매뉴얼 - 페이지 24

{카테고리_이름} Cisco 7513 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 44 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 매뉴얼 (30 페이지), 유지 관리 (20 페이지), 교체 지침 매뉴얼 (19 페이지), 교체 지침 매뉴얼 (22 페이지)

페이지 인쇄

Start and Conﬁgure the System

Perform a Basic Conﬁguration

Using Conﬁguration Mode

At the reboot, the following example appears:

Any interface listed with OK? value "NO" does

not have a valid configuration.

Interface IP-Address OK? Method Status

Protocol

Ethernet0/0 unassigned NO not set down down

Serial1/0 unassigned NO not set down down

Step 1

Enter the conﬁgure terminal command at

the enable prompt to enter conﬁguration

mode from the terminal, as follows:

Router# configure terminal

Enter configuration commands, one per line.

End with CNTL/Z.

Router(config)#

Step 2

Enter the interface type slot/port

command at the enable prompt to enter

interface conﬁguration mode, as follows:

Router(config)# interface serial slot/port

Router(config-if)#

Step 3

Press Ctrl-Z to exit conﬁguration mode.

Step 4

At the # prompt, enter the copy

running-conﬁg startup-conﬁg command

to save the conﬁguration to NVRAM as

follows:

Hostname# copy running-config startup-config

Your Cisco 7513 or Cisco 7576 router is now

minimally conﬁgured and ready to use. If you want

to modify the parameters after the initial

conﬁguration, use the setup command. To perform

more complex conﬁgurations, use the conﬁgure

command.

For more information on additional interface

conﬁguration and information on more speciﬁc

system conﬁgurations, refer to the Cisco 7500 Series

Installation and Conﬁguration Guide.