Cisco 7513 Series Hızlı Başlangıç Kılavuzu - Sayfa 24

Ağ Donanımı Cisco 7513 Series için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco 7513 Series 44 sayfaları. Chassis replacement
Ayrıca Cisco 7513 Series için: Değiştirme Talimatları Kılavuzu (26 sayfalar), Veri Sayfası (11 sayfalar), Manuel (30 sayfalar), Bakım (20 sayfalar), Değiştirme Talimatları Kılavuzu (19 sayfalar), Değiştirme Talimatları Kılavuzu (22 sayfalar)

Start and Conﬁgure the System

Perform a Basic Conﬁguration

Using Conﬁguration Mode

At the reboot, the following example appears:

Any interface listed with OK? value "NO" does

not have a valid configuration.

Interface IP-Address OK? Method Status

Protocol

Ethernet0/0 unassigned NO not set down down

Serial1/0 unassigned NO not set down down

Step 1

Enter the conﬁgure terminal command at

the enable prompt to enter conﬁguration

mode from the terminal, as follows:

Router# configure terminal

Enter configuration commands, one per line.

End with CNTL/Z.

Router(config)#

Step 2

Enter the interface type slot/port

command at the enable prompt to enter

interface conﬁguration mode, as follows:

Router(config)# interface serial slot/port

Router(config-if)#

Step 3

Press Ctrl-Z to exit conﬁguration mode.

Step 4

At the # prompt, enter the copy

running-conﬁg startup-conﬁg command

to save the conﬁguration to NVRAM as

follows:

Hostname# copy running-config startup-config

Your Cisco 7513 or Cisco 7576 router is now

minimally conﬁgured and ready to use. If you want

to modify the parameters after the initial

conﬁguration, use the setup command. To perform

more complex conﬁgurations, use the conﬁgure

command.

For more information on additional interface

conﬁguration and information on more speciﬁc

system conﬁgurations, refer to the Cisco 7500 Series

Installation and Conﬁguration Guide.