Cisco 7513 Series 빠른 시작 매뉴얼 - 페이지 7
{카테고리_이름} Cisco 7513 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 44 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 매뉴얼 (30 페이지), 유지 관리 (20 페이지), 교체 지침 매뉴얼 (19 페이지), 교체 지침 매뉴얼 (22 페이지)
Install the Hardware
Mount Brackets to the Rack Posts
Note
The distance between the inner edges of the
left and right rack-mounting posts must be at least
17.72 inches (45.088 cm), and the distance between
the holes in the mounting posts must be 18.31 inches
(46.5 cm) (+ .063 inches or .16 cm).
Step 1
Place the bracket on the inner side of the
rack post, with the flanged front edge of
the bracket in front of the rack post.
Step 2
Align the mounting holes in the bracket
with those in the rack post.
Step 3
Support the bracket with one hand, and
use the other hand to insert a 10-32 x
5/8-inch LG Phillips pan-head screw
through the bottom mounting hole on the
front of the bracket and into the rack post.
Rack post
Flange
Step 4
Step 5
Step 6
Step 7
Secure the top of the bracket to the rack
with two pan-head screws. Finger-tighten
the screws.
Push the brackets as far apart as possible
before using a Number 2 Phillips
screwdriver to tighten the screws.
Adjust the brackets if the distance
between them is less than 17.5 inches
(45.45 cm).
Repeat Step 3 through Step 6 for the
remaining bracket. Use a level or tape
measure to ensure that the two brackets
are level in the rack.
5