Cisco 7513 Series Hızlı Başlangıç Kılavuzu - Sayfa 7

Ağ Donanımı Cisco 7513 Series için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco 7513 Series 44 sayfaları. Chassis replacement
Ayrıca Cisco 7513 Series için: Değiştirme Talimatları Kılavuzu (26 sayfalar), Veri Sayfası (11 sayfalar), Manuel (30 sayfalar), Bakım (20 sayfalar), Değiştirme Talimatları Kılavuzu (19 sayfalar), Değiştirme Talimatları Kılavuzu (22 sayfalar)

Install the Hardware

Mount Brackets to the Rack Posts

Note

The distance between the inner edges of the

left and right rack-mounting posts must be at least

17.72 inches (45.088 cm), and the distance between

the holes in the mounting posts must be 18.31 inches

(46.5 cm) (+ .063 inches or .16 cm).

Step 1

Place the bracket on the inner side of the

rack post, with the ﬂanged front edge of

the bracket in front of the rack post.

Step 2

Align the mounting holes in the bracket

with those in the rack post.

Step 3

Support the bracket with one hand, and

use the other hand to insert a 10-32 x

5/8-inch LG Phillips pan-head screw

through the bottom mounting hole on the

front of the bracket and into the rack post.

Rack post

Flange

Step 4

Step 5

Step 6

Step 7

Secure the top of the bracket to the rack

with two pan-head screws. Finger-tighten

the screws.

Push the brackets as far apart as possible

before using a Number 2 Phillips

screwdriver to tighten the screws.

Adjust the brackets if the distance

between them is less than 17.5 inches

(45.45 cm).

Repeat Step 3 through Step 6 for the

remaining bracket. Use a level or tape

measure to ensure that the two brackets

are level in the rack.