Cisco 7513 Series 유지 관리 - 페이지 8

{카테고리_이름} Cisco 7513 Series에 대한 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 20 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (44 페이지), 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 매뉴얼 (30 페이지), 교체 지침 매뉴얼 (19 페이지), 교체 지침 매뉴얼 (22 페이지)

Maintenance Procedures for the Cisco 7513, Cisco 7513-MX, and Cisco 7576

Figure 7-5

Figure 7-6

Chassis

interface

board B

Step 5

Remove the old EEPROM devices from the old card cage. Note where pin 1 is and use it as a reference

insertion point. Immediately install the old EEPROM devices on the EEPROM sockets on your new card

cage. (See

Install the blank EEPROM devices)(that you removed from your new card cage and marked with tape)

Step 6

on the EEPROM sockets on your old card cage; remove the small piece of tape from the blank EEPROM

devices. Return the old card cage to Cisco Systems.

Repeat Step 5 and Step 6 for the second EEPROM in the Cisco 7576.

Step 7

This completes the procedure for exchanging the EEPROM devices, which is required only if you

exchange your existing card cage assembly for a new one.

Cisco 7500 Series Installation and Configuration Guide

7-8

Location of the EEPROM Device on the Rear of the Card Cage (Cisco 7513 and

Cisco 7513-MX)

EEPROM

device

Pin 1

Location of the EEPROM Devices on the Rear of the Card Cage

(Cisco 7576)

EEPROM B

Pin 1

Figure 7-5

for the Cisco 7513 and Cisco 7513-MX, and

Chapter 7

Maintaining Your Cisco 7513, Cisco 7513-MX, and Cisco 7576 Router

Chassis

interface

board

Chassis

interface

board A

EEPROM A

EEPROM device

Figure 7-6

for the Cisco 7576.)

OL-5008-03 B0