Cisco Aironet 1140 Series 구성 매뉴얼 - 페이지 9

{카테고리_이름} Cisco Aironet 1140 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1140 Series 40 페이지. Autonomous access point
Cisco Aironet 1140 Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (35 페이지), 데이터시트 (6 페이지), 시작하기 매뉴얼 (37 페이지), 시작하기 매뉴얼 (31 페이지)

페이지 인쇄
Cisco Aironet 1140 Series 구성 매뉴얼
Section 1: SVP

Installing Software

10. Add the
11. Allow a few minutes for the download to complete.
12. Reboot the Controller

Controller Setup

PN: 1725-36192-001_H
Cisco Wireless LAN Controllers with 1100, 1130, 1140, 1200, 1230, 1240, 1250 APs
1. Make sure that the correct version of software, listed in the Product
Summary, is installed on the controller. From the main menu, click
Monitor.
2. In the navigation pane, click
shows the current software version.
Version
3. Download the appropriate software for your model of controller from
the Cisco website
.
4. Set up a Trivial File Transfer Protocol (TFTP) server running on a PC
to download the file to the controller.
5. Connect to the controller via a Web browser.
6. From the main menu, click
7. In the navigation pane, click
8. For
, select
File Type
9. For
, type in the IP Address of the TFTP server.
TFTP Server
File Path
and not the system path where the TFTP server is located) and
of the firmware file to download.
Name
(Note the example simply uses the /designator for the root TFTP
directory.) Point the TFTP server to the code.
The initial setup of the controller is shown below.
. The heading labeled
Summary
.
Commands
Download File
.
Code
(this is the path in the TFTP server's root directory
Software
.
File
9